Wire Harness Wrap – 50 Series – 5 mil

SPVC film coated with a rubber based adhesive.

High elongation and excellent conformability for wire harnesses.

Matte finish.


A 5 mil SPVC film with rubber based adhesive for wrapping of harness wires.

Item # Roll Size Units / Case Case Size Case Weight
12050 3/4″ (19mm) x 60 ft 200 / case – Cello 15″ x 12.2″ x 8.7″ 30 lbs

Technical & Consumer Data

Physical Properties

Total Thickness: 5.0 mil
Tensile Strength: 14 lbs. / in.
Elongation at Break: 200 %
Adhesion: 11 oz. / in.
Dielectric Strength: 5.5 KV
Unwinding Force: 25 oz. / in.
Temperature Rating: 80ºC (176ºF)

Physical and performance properties shown are averages obtained from test recommended by ASTM D-1000 or our own procedures. A particular roll may vary slightly from these averages and it is recommended that the buyer determine the suitability for his own purposes.

Tape does not meet REACH, RoHS or Prop 65 compliance standards. Requires Prop65 warning label when shipped into California.


Technical Data Sheet

You may also like…